Quantum, offering you the customer something a little extra. All Quantum Cables are pre-burned on the AudioDharma Cable Cooker®. Yes, even our Eichmann Power Cords are pre-burned. What this means for you is your cables are immediatedly ready to perform at their best in your system, the day they arrive. No waiting weeks for them to burn in to a level that still may not achieve what the Dharma can achieve.

According to AudioDharma Manufacturer: The CABLE COOKER™ was designed to produce signal levels far in excess of those seen in normal audio/video system use. Internally, the device contains a sweeping square wave oscillator that drives a very high-efficiency "H" bridge MOSFET switching circuit. The output signal consists of a square wave from below 100Hz to over 16k Hz (plus harmonics). Output voltage is 12 volts rms. The current through the wiring component is determined by the load at the input connector of the CABLE COOKER™. In the case of interconnect cables, the measured current is 120 milli-amperes. Installing an interconnect on the CABLE COOKER™ for one week results in a CTV of: 168 hours x 0.12 Amperes = CTV of 20.16 This is a value 600 times greater than that obtained under the most ideal of audio system conditions. The "stress" on the dielectric of the interconnect is also much higher than in normal use due to the higher output voltage. It should be readily apparent why results with the CABLE COOKER™ are often quite audible after as little as 24 hours of use.